Baseline-systems BaseStation 1000 Manual do Utilizador Página 121
- Página / 122
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
BaseStation 1000 Irrigation Controller Manual
maximum
allowed
depletion
(MAD)
When the soil moisture content reaches this level, irrigation needs to start.
In most cases, the maximum allowed depletion level is just before the plants
begin to show visible signs of stress.
microclimate
The climate of a specific location within a landscape. Variations in climate
are influenced by subtle differences in temperature, humidity, and wind
exposure. Microclimates can have a significant impact on plant water needs.
NCMV
Normally closed master valve – built in to the BL-5402NCMV flow device
NOMV
Normally open master valve – built in to the BL-5402NOMV flow device. It
can monitor high flow and shut down independently from the controller.
offset value
A calibration factor for a flow device that compensates for limitations in the
device’s ability to measure small signals adequately. Manufacturers give the
maximum amount of offset associated with their flow device in the device
specification
permanent
wilting point
When soil moisture content reaches this level, plants can no longer get
water from the soil, and they will wilt and die
powered
biCoder
A decoder device that interprets the signals that it receives from the
controller and tells the valve to turn on or off. A powered biCoder is
designed to retrofit into existing systems and requires 120 VAC service at
installation location.
program
The controller uses a program to organize watering events. Each program
can have different schedules, water days, start/stop/pause conditions, and
associated devices. The BaseStation 1000 supports 20 programs and can be
upgraded to support up to 40.
pump start
A relay or relay-type device that initiates turn on of a pump, typically a high
horsepower electrical or motor driven pump
runoff
When the soil moisture content is at the saturation level, any excess water
from rain, snow melt, or irrigation drains to a low point in the landscape
saturation
When the soil moisture content is at this level, nearly all of the spaces
between soil particles are filled with water. After a soil has reached
saturation, it does not become more saturated; although, in some situations
where water is trapped, it can become flooded.
soak cycle
When a zone waters using a soak cycle, the total watering run time includes
periods of watering (run times) interspersed with periods of non-watering
times (soak times).
soil-moisture
content
The ratio of the volume of contained water in a soil compared with the
entire soil volume
Page 115
- BaseStation 1
- Table of Contents 3
- 1 – Introduction 7
- Soil Moisture Content 8
- Choosing the Sensor Location 11
- Burying the biSensor 12
- Trees and Shrubs 13
- Watering Strategies 14
- Understanding Soak Cycling 16
- Intelligent Soak Cycles™ 17
- Distribution Uniformity 18
- Recommendations 20
- 2 – System Components 21
- Remote Communication Options 22
- Two-Wire Devices 23
- Maximum Concurrent Valves 25
- C-Series Wall Mount Cabinets 26
- Connecting Power and Ground 27
- P-Series Pedestal Cabinets 28
- On-Screen Help 30
- Zone Status Report 30
- BaseManager Message 31
- 4 – Configuring Devices 32
- Setting Up Zones 33
- (biSensors) 36
- Setting Up Moisture Sensors 36
- Setting Up Flow biCoders 37
- Setting Up Event Switches 39
- Unassigning a Device 40
- Restarting the Controller 42
- Setting Up Programs 44
- Setting Up a Rain Delay 62
- Setting Up Event Days 63
- Enabling Flow Variance 68
- Learning Flow 70
- Learning the Flow by Zone 71
- 7 – Manual Operations 72
- 8 – System Setup 78
- Controller 86
- Adding Expansion Modules 93
- Understanding Zone Statuses 95
- Viewing Operator Messages 98
- Viewing Moisture Graphs 100
- 10 – Testing Devices 102
- Testing Flow Sensors 106
- Testing Event Switches 106
- Testing the Two-Wire 107
- Testing All Devices 108
- Troubleshooting Manually 110
- 11 – Appendix 111
- Based Watering 114
- Configuring a Booster Pump 115
- Page 112 118
- Glossary of Terms 119
Manuais e produtos relacionados com Sensores Baseline-systems BaseStation 1000
(12 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.039 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais